Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have CIsco LMS 3.2The problem is that one of the locations which was installed with CIsco 1841 Router has been replaced with Cisco 1941from where i can get the report displaying the previous and the new replaced model ? Thanks
Hi, I have a couple of questions regarding the service policy of CISCO ASA1) when inspect http is disabled in default policy we cant RDP to the desktops connected to the ASA , also when inspect icmp is disabled i cant ping through the ASA but when it...
Hi,I recently upgraded from 3.1 to 3.2 it was working fine however one day CS is displaying the message "DCR Server is down or inaccessible" , i have restarted the Daemon , restarted the server as suggested in some other posts but to no success any o...
Hi,If i am buying Cisco IPS with three year warranty then the license file i get for the sensor is for lifetime or for three years ?I have heard that the IPS will continue to receive updates even after 3 years and is a lifetime license Is this corre...
Hi, I have recently started working on Cisco LMS and have some doubts regarding it , i will be really grateful if someone can clarify my queries.1) In DFM Module what does the duration signify in "High Severity Alerts" ?2) what should be the data col...
i did nothing in the LMS, at the end location device was replaced and snmp credentials were entered , LMS updated itself with the new details under the previous device credentials.Now i cant see what was the last device under the same name in LMS
Thanks for the reply Afroz,no i havnt deleted the previous device , the new was replaced at the end locationnow when i run the report from inventory it gives me current device information ,not the previous deviceThanks
