Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone help me with this?I followed the installation guide, mounted the ISO image to the virtual CDROM on UCS Central VM and tried to boot it from CD but with no luck. VM is trying to look for a linux CD to boot (see attached). I am struck on t...
I see these 2 errors in few of our blades after upgrading them to 2.1(3a).F1237 - Health LED of server 1/1 shows error. Reason:RAID_BATT_FLT:Sensor Failure Asserted;F0531 - RAID Battery on server 1/1 operability:inoperable. Reason:Any inputs on these...
Can anyone let me know if this requirement is possible with Cisco PIX?I would like to redirect HTTP requests from hosts in INSIDE to a proxy server in DMZ so as to restrict the users to use proxy for Internet access.RegardsSubbu
Hi,I see that the CPU utilization is very high (around 80%) in my 7206VXR-NPE300, though none of the processes use more than 1%.While going through some 'show' outputs, I saw that the 'CEF Drop Statistics' was incrementing. Will this have any impact...
Yes, I followed those steps and mounted the Password Reset ISO image to the virtual CD drive. But, when I tried to boot the VM with it, I am getting the error (see my attachement) instead of the 'UCS Central Admin Password Reset' page as in step #3....
Hi Chris,Is there a way to confirm if the battery needs a replacement? Or is it always assumed that it needs to be replaced for the fault code:F0531?Subbu
Hi,'fixup' command in the version 6.3 is replaced with 'inspect' in 7.0 and above.Check this link for more info.http://www.cisco.com/en/US/docs/security/asa/asa70/pix_upgrade/upgrade/guide/pixupgrd.html#wp1201896RegardsSubbu
