Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a scenario where HP 5900AF-48XGT-4QSFP+ TOR Switch needs to connect to Cisco 6509E aggregation switch over 10G uplinks, could I use 5m 40GE/10GE HP splitter (JG331A) to achieve the scenario ? Does Cisco support HP splitter ?If not, how ...
Hi,I'm building a wired closet to aggregate user's connections, Im planning to have 5x 3750X stacked switches and there is a need to run EIGRP, I'm thinking to order one switch with IP service image while the rest will run IP base image, is it workab...
Hi All,Any one had implemented AP1261 using third party 2.4Ghz antenna with power gain more than 6 dBi ?I'm planning to use 18dBi Non Cisco antenna that support MIMO but I have found the note below on cisco N-antenna datasheet.. Technically i'm not c...
Hi,The scenario as following, I have two ASA5510 running version 8.0(5) and connected over Internet via IPsec dynamic to static L2L (obviously the static one is on HQ), it works perfectly fine with no issue. I have configured remote access VPN to ter...
Trust me, it depends how u understand and translate "software mixed stack" , it seems they meant by "software mixed stack" different IOS versions from the same feature set not different feature set Images???If this is the case then you r right )Se...
Your solution make sense to me,, but as per cisco Q&A, you can stack any IOS feature set in the same stack (software mixed stack) which contradict with your explanation !!!Could u plz elaborate more,,Sent from Cisco Technical Support iPad App
i believe i have to use 6 dBi omni antenna and increase number of AP's, cost will increase accordingly but what to do since no alternatives are available !!!!Sent from Cisco Technical Support iPad App
Why not !!Since cisco have already outdoor antenna with gain of 12 dBi but not "approved" as they claimed for AP1260, i believe not approved means not tested in their lab but practically if i connect third party antenna (18dBi) to AP1261 technically ...
