Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We have deployed 2 WAAS appliances lately and have SAP printing issues.The network architecture is as follow : - WAAS 574 on the Data Center "inline"- WAAS 274 on the Branch "inline" as well- WAAS IOS is 5.0.3Branch users do, most of the time,...
Hello,We installed a WAAS 574 (IOS 5.0.3) inline between a switch and a router.It's a Giga switch and Fast router.What does Cisco advice to do in this situation ??We set all the ports (Switch, WAAS inlinegroup, Router) to 100M Full to avoid speed dif...
Hi,We deployed couple of WAAS and have some wired values on the "Connections Statistics" window on the CM. Basically, for some flows the Original Bytes value is lower than the Optimized Bytes one ...Howerver for these flows the 3 optimization icons D...
Hi,We deployed a WAAS 694 lately and have the following issue.The version used is : 4.4.5This appliance has 2 PSU working just fine (we tested it), but we have the following alarm (show alarm detail) : Critical Alarms: ...
Just after the WAAS has been installed, it worked. At some point, it stopped (like half a day after the last time it occured).As far as I understood, SAP printing works as below : - a SAP printing is launched from the SAP software- the request is sen...
In conclusion, I can set up my equipements in the following manner without any problem : - WAE in Auto/Auto- Giga switch port in Auto- Fast router port in AutoNormal state : - switch to WAE LAN : Giga connection (straight-through wire)- WAE WAN to ro...
It means that in a WAE hardware issue situation, the Giga switch and the Fast router should negotiate 100M connection speed.So, no problem right ?!Regards,Ismael
Hi Nicolas, Thanks for the quick answer.We did exactly this type of cabling when we tried to use FE on both sides : - straight-through between switch and WAE- crossover between WAE and routerTraffic loss appeared however.I am not sure how the WAE beh...
