Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We send traps to ForeScout servers when a new mac is learned on our IOS and IOS-XE switches. I can't seem to find how to do that on our Nexus 5548UP switches. Here's our current command set on our non-Nexus switches:
Global configuration
snmp-serv...
We've been configuring our swtichports as follows for our 7945 and 6941 type VoIP Phones, but are having problems witht the 6901.VLANSVlan 900 is a VoIP VLAN Vlan 999 is a NULL VLAN and is shut down:interface g0/1switchport access vlan 999 {VLAN t...
Here's what I learned concerning this issue:
We can't try the commands below since we're on 7.0(6)N1(1).
Unfortunately, SNMP traps for mac-moves are not available on the Nexus 5500 and not on the roadmap. With NX-OS 7.1 and later, you can send syslo...
Update, TAC suggested that we configure our multicast handled by the controllers to multicast (not unicast, which is how we're configured). We are looking into making this change, without enabling multicast service on the rf side of the house to hel...
keithsauer507, did you ever get this issue resolved? We have the same problem with our 3502, 3602, and 3702 LWAPs. Only difference is that we're not getting output drops on our switches feeding the problem LWAPs. All of the LWAPs hanging off this ...
Did you ever get a reply to this?Just go into your global configuration and change the RP register to 0x2102. This will configure the SP to change to the same value on reboot.Sam
Update: A new Cisco bug has been created for this issue. Our Cisco 6901 VoIP phones will (in most cases) not work when connected to a C3560G or C3560X with a switchport data vlan applied and placed in a shutdown state. We do not have this problem ...
