I have two groups of 1602e access points; one using the 15.2(2)JB firmware and one group using the 15.2(2)JB2 firmware. The JB firmware does not have this problem but all 25 of the JB2 firmware AP's will not save "power local max" settings that I en...
I am using a SF300-24 switch with 12 POE WiFi access points in a residence hall. Occasionally, an AP's signal will get so weak users are unable to associate their phones or laptops with it. Disabling the relevant port remotely for a minute o...
I would like to enable "client isolation" on an autonomous, standalone 1142N AP but I don't see that option anywhere in the web interface. Could anyone tell me how to keep associated clients from passing traffic to one another on this AP? ...
Is there a way to start with a LAN MAC address for a Cisco 1100 Series AP and look up the corresponding wireless MAC address and vice-versa? What I am looking for is either a cross-reference table or a lookup program where one of the MAC addresses w...
The 15.2(4)JB5 fw upgrade actually worked for me on all problematic 1602e's. Now they hold the proper config, including max power settings, after reboot.
I have tried different configurations of the Time Settings/Time Range commands and nothing seems to effect the status of the POE port, it doesn't go "down" at the specified time. First I tried using the 0:0:0 - 23:59:00 uptime schedules and that did...
I'm also having some trouble telnetting into the switch. I always get "connection refused" after I enter the IP address. I have set up "admin" for the access profile. Do I need to do anything else?
Thank you, Tom, for the suggestion. Will the command above automatically reboot the switch each day at 23:59 without me having to do anything manually?Jerry