Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA 5510 running v8.2, and I just started having an odd issue with one endpoint.
I have 20-30 remote Avaya IP Phones, all connecting via IPSec VPN to the ASA, but one of them has recently started to leave 'stale' tunnels and build new ones ...
I have a new issue that cropped up after I updated our 5510 to 8.2(5)59. We have several ASAs at different sites, and have been using both AnyConnect VPN and the older Cisco IPSec VPN. From outside all of the networks, both VPN types work just fine t...
In the 'Home' page of the ASDM, there is the 'Interface Status' box that shows the status of each interface and how much bandwidth each one is using. Is there any place in the ASDM that I'm missing that can show real-time bandwidth usage for each of ...
I have an ASA5510 in use that I have set up to block pings on the outside interfaces using 'icmp deny any Outside' and 'icmp deny any backup'. Currently, I simply have a secondary route with a higher metric that points out our backup connection. The ...
I currently have a pair of Adtran Netvanta 1224R units that I want to replacce with Cisco 1760 routers. How can I translate the existing QoS (relevant sections below) on the Adtrans to work on the Cisco routers:!no ip firewall alg msnno ip firewall a...
Just an update and a little more information. I've determined that we have four users that have Comcast for their internet connection. Of these, three are having this issue and one does not appear to be at this time. The three that are having the iss...
Thanks Joseph. From your answer, I was able to get a little more info. I think you were missing the Access list that would tell the router what should be given priority. It seems that without an ACL, nothing would match so nothing would be given prio...
Three of the routers are 'C1700 Software (C1700-IPBASE-M), Version 12.3(2)T8' and one is 'C1700 Software (C1700-Y-M), Version 12.2(15)T10'. The serial port is a WIC-1DSU-T1 on all with the full 1.544Mbps bandwidth available. I'm not positive on the s...
I've tried all you suggested (9600/8/n/1, standard serial, not USB adapter), I can't try another PS because I don't have another, but I took the power injector apart and tested the voltage that the AC adapter was putting out and it was about 48VDC, a...
