Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a network setup where Cisco Anyconnect clients are failing to get an ip address from an internal DHCP server. I have set this type of configuration up before and it works ok. The difference this time is I think the router between the ASA and t...
I am trying to see if this can be done... I know the best practice is to give VPN clients IP addresses on a different subnet than the ASA's interfaces, but in my current situation, I need them to have the same addresses as the company LAN. We have ma...
I am experiencing a very annoying problem. Whenever I connect to the ASA 5510 (v8.2) via SSH I randomly get disconnected. this happens usually within a minute or two, sometimes just 5 seconds. The screen seems to freeze up and within 5 seconds the co...
We currently have 3 networks - Support, Monitoring and Client where we are trying to allow our support network to access a server in the client network.Normally we would create VPN's between the client site and both our Support and Monitoring network...
I am setting up a network design where two sites will have the same IP addressing scheme (Production and DR). I need to configure the ASA devices at Production and DR with NAT so that servers in production can replicate information to servers in DR a...
Thanks Vincent. Can you elaborate more on your response? AFAIK, the ASA sends a unicast packet to the DHCP server, so I'm not sure dhcp relay is going to work. Out of curiosity, I did set that up on the routers external interface but it made no diffe...
OK, I have done some packet analysis and I have found the problem. I'm not sure how to fix it though. It appears as though the DHCP server is receiving the request coming from the ASA's network interface and because it is on a different subnet than t...
Thanks. The settings seem to be correct, and the ASA can definitely reach the internal network because AAA authentication with the Windows domain controller is working ok. It just looks like the request for an IP address from the DHCP is not happenin...
Hi Bikas, using a pool is one of the 3 methods of IP assignment available on the device. We can create a local pool of addresses and clients connect without issue. We however need our anyconnect clients to use the internal DHCP server for their addre...
