Hi,I just want to clear this off my chest. We got a change and it involves adding new switches and adding new vlans. so our vendor will need to add the new vlans to the global spanning-tree config.we got something like spanning-tree vlan 1, 4, 6 prio...

Hi,Has anyone run into issues with the cisco dynamic configuration tool? I recently noticed I cannot customize the hardware I am trying to configure. This was not like this in the past.

Hi,could anyone point me in the right direction. not too catOS savvyI need to get the mac addresses and ip addresses off a few interfaces to which servers are connected to on a 6500 catOS switch. could point me to the commands i can issue to get thes...

Hi,I would like to inquire if any of you guys know the maximum amount of traffic a 3825 router can take. I know that a 3825 is rated to handle half of a DS3/T3. We are planning to put a 50Mbps point to point metro ethernet circuit between two 3825's ...