Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
If suddenly license expired, will router unable to be configured with BFD? Originally, router is configured using BFD. Then, noticed that router down and unreachable remotely. But later when I checked the syslog, there was no log that indicate ...
Hello All,
I need help on the explanation from "show hw-module" output for below particular section (bold) of the output. What does the output mean?
I try to search for document but couldn't find any. And from the command, how do I verify the operat...
Hello,I'm not sure what problem that I'm facing but hoping any expert here could help. Customer router, CE HQ site is connected to 2 ISP PE router , PE-a and PE-b using OSPF. PE-a act as active link and PE-b act as backup link.All customer branches s...
Hi All Cisco and Network Expert,Need some advise on the current issue that I'm facing right now.The problem is that my customer observes input error,frame error and realibilty drop at only Multilink Interface. No error detected at the serial interfac...
Hello,I have one scenario. One end is using Cisco router and the other end using Juniper router have been configured eBGP Multihoming using loopback IP. At each router, two interface have been configured and both static route has been pointing to the...
Hi Georg Pauwen
Same. Cannot configure.
Router(config)#interface bdi1000
Router(config-if)#bfd ?
% Unrecognized command
Router(config-if)#bfd
Below are the original configuration from backup rancid.
bfd-template single-hop BFD300
interval min-...
Hello Edison,Thanks for replying. Very helpful Btw, is the any reason or where I should start to check when there is only one entry of default route when issuing command show ip ospf database external 0.0.0.0?
