Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have DNS issue on the firewall, although DNs has been configured as below but we firewall 'debug dns' still showing below error message.FirePower/pri/act# ping www.google.com ^config:=======dns domain-lookup ...
Hi,I have new FirePower ASA 1120 to register for Smart license. I have used the usual process to get the Token form the Cisco Smart account and add it to the device. Although I have 10 devices license available but my license status remain as below;...
Hi, Please guide that when configuring NAT on the Cisco ASA, do 'Original Destination IP' & 'Translated IP' should be routed through same interface? Or is it possible that 'Original Destination IP' belongs to "dmz" interface and 'Translated IP' route...
Hi,Please guide to upgrade the ASR1001-X with below queries; Question1: I like to upgrade to new recommended version i.e. asr1001x-universalk9.17.03.04a.SPA.binIs it direct upgrade, from current Version 16.03.07 ?Question2: Do I need to upgrade the R...
Hi, I want to extract the APIC config that which BD(subnets) is linked with which EPG & further how that EPG is configured with , Physical port, encap, Domain(Phy/VMM) and IPG. I want to extract the information on excel to get an overview of the APIC...
Hi Leo, Thanks for sharing the details.1) In the guide of above link , its mentioned as below(that boot-variable should point to “packages.conf” file"), but my current boot variable is pointing to .bin file, and router is working okay. Please advice ...
Hi @Sergiu.Daniluk Have you used the tool. 'Network Deployment Tool', I have heard that it can import the config e,g Tenant/EPG and contract from excel sheet, then validate with ACI via python, once satisfied, PUSH the config. All config Push and Va...
Thanks a lot to both @ecsnnsls & @RedNectar Much appreciated.@RedNectar Thanks a lot for spending your Sunday time for me When I enter below cmd, I get output as below, hope something not gone wrong, please advise apic1# bashAPIC-01:~> icurl -s -k "...
