Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
Cisco CSR1000V router to which AnyConnect users and terminated IPSec with remote LAN.
LANs 10.251.0.0/24 hosts are available via IPSec to remote LAN hosts 10.120.0.0/16
To Clients AnyConnect 10.251.100.0/24 is available LAN 10.251.0.0/24
The...
Good day!In my possession Cisco ASA 5515 and three interfaces: LAN 10.1.1.1 (network 10.1.1.0/24)WAN1 1.1.1.130 (network 1.1.1.128/26)WAN2 1.1.2.5 (network 1.1.2.0/24) Now the traffic goes through WAN1 - all web-application in NAT address pool 1.1.1....
Good day! Friends, faced with strangeness when configuring protocol BGP - one of the boarders, I do not see prefixes that advertises my other Border ... In order ... There are two boarders are included in the AS78: Point1 - announcement 10.32.19.0/24...
Good day!The situation is as follows:There is an Internet Service Provider (ISP1), has a Cisco ASA (8.4) (ASA1) with the external IP 1.1.1.1, there WEB-server with the internal address 10.0.0.186, which run web-application.On ASA1 configured NAT: ...
Can I do that both were available IP interface from outside the network? It is necessary for IPSec connections as WAN1 through and through WAN2 from external hosts.
Harold, thank you, it really works!But I still have one more question:I'm going to make an internal joint Point1 and Point2 via iBGP, each of which will only announce their prefixes. Do I need to use in this case "allowas-in"?, Because the path will ...
