Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Troy,No, you don't have to delete line 10 from ACL 106, if you will do so you will break your L2L VPN connectivity. All you need to do is to use a static nat statement together with this route-map:ip nat inside source static tcp (internal host)...
Hello Stephanie,If you use Cisco Configuration Assitant to configure Multisite dialing, voice vlan subnets are not important - they may overlap, because for multisite dialing both UCs will use their VLAN1 interfaces. So, VLAN1 subnets should be diffe...
Hello Troy,I beleive you need to add a 'route-map' statement to the static NAT to exclude VPN traffic. Since you have a L2L VPN, you should also have VPN traffic excluded from your general NAT overload, if you use one. Your overload NAT statement may...
Hi Ellis,Please, check in QoS Parameters page of AP web GUI if "QOS Presets" option is set to ""Optimized for Voice". Normally it helps to enforce proper data queueing depending on data type and put voice traffic into appropriate queue. For more QoS ...
Hello Sherwin,Do you use CCA or CUE's web GUI to configure the Auto Attendant? If you use CCA, please, ensure that your PC has an access to CUE's IP address (default one is 10.1.10.1). Also, when you change AA script CCA instructs CUE to download the...
