Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good evening, we are running a CISCO 2960X with an LACP etherchannel to a port bond on our Checkpoint with abouth 7 VLANs using the bond.This was running fine on 15.2(2)E4.In a short maintenance we rebooted the switch, knowing that it would upgrade t...
Hi everyone,we are currently in migration phase of WCS to Prime 1.3 and at this moment we are encounter the following error:We are migrating the databases at appliance 1, then backup the databases and restore it at appliance 2. This process is needed...
Hi there! Thank you for your fast reply.Checkpoint is running on ClusterXL. The Port-Channel and it's ports are configured as following:Both Gigabitports are configured for trunk and channel-group 20 mode active.interface Port-channel20 description C...
Today we could figure out that the update 1 for Prime Infrastructure was blocking the restore process.You can't remove the patch. When you try the command "patch remove NCS..." you get an error that this command does not apply on this patch version.....
