Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I mistakenly deleted the IOS from Cisco 3560 switch. Actually I wanted to upgrade and I uploaded new image and deleted previous one.But new image did not match with switch firmware and switch ended up looping boot process.I deleted new image as we...
Hi,I cant ssh to inside interface access of ASA5505 firewall wihile ASDM and telnet are working. I have opened SSH access along with telnet and ASDM.I can ssh to outside interface. Its very wied problem that SSH on inside interface is not working.B...
HiI have configured cico Call manager 8.6 on cisco 2901 router.I have one BRI installed at 2901.The problem is that, when I call outside from any desk phone except the console phone the number that displays on the receiver's phone is completely di...
HiI have two 3750 switches installed and both switches are conncted via optical Fiber as both are in different offices.On one of 3750 siwtch Orange light is flashing on GBIC port 25 This port has optical fiber GBIC module installed.On other switch it...
I recently purchased cisco 2901 router and installe CME 8.6. I already have VIC2-2BRI-NT/TE card installed in the cisco 2611XM router. The 2611XM router will be repalced with 2901 router.But cisco 2901 did not detected the VIC2-2BRI-NT/TE card. The I...
Yes I wanrt to use the same imsage which was correct and I have deleted. I have its copy in my computer. I have tried that document but file transfer failed everytime. I ma unable to transfer image file from PC to Switch!!Is there any other solution...
Hi I have run SSH DEBUG command but I am not getting any output on prompt.I am not getting any log on ASDM as well. I am getting the following error when trying ssh to inside interfaceThe session used to hang up for 2-3 minutes and then returned the...
Hi Jouni FrossYes I am trying to access on inside interface. Please find below the output of command. I am not sure how can I monitor via ASDM. can you please helpThanksmahmoodProtocol Socket Local Address Foreign Address S...
