Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We can use TACACS+ and ACS to do the command accounting for EXEC shell commands executed. But what abount configuration changed by SNMP set? How to find out which OIDs set by NMS tools?Thanks!
Hi,We have a 3825 router with three PVDM2-64 and one PVDM2-48. With 16 DSP channels in NM-HD-2V, it has 256 channels in the router.Recently we found that lots of DSPs are used with small amount of active calls.The following image shows that the DSP u...
I setup a radius server to apply aaa on routers and switches.In routers, using local privilege and work well. In switches, it just gets into exec mode. When I set radius profile, just one 6509 can become enable prompt, others fail.I checked the versi...
I set a switch to use radius server. And I left a backdoor for local. The command as :set authentication login local enableset authentication radius enable telnetBut when the radius down, switch still show user/password.When I put username(whatever)/...
Yes, I had read it hard. But when I set Service-type to 6, some switch works and some doesn't. I want to know the different between those.Thanks for your reply!
Yes, I have checked the article. But in the STEP B, it configure radius used local as a backdoor, which catos is from 5.1 to 7.5.1.I just wander how it works at catos before 7.5.1
