Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have recently started a new position in which I am facing a daunting task of cleaning up of ACP. What I would like to understand is what should be my approach to do it. There seems to be a lot of stale entries in there but I have no way of k...
I have a muti-pod golf router setup. I have some IPv6 enabled machines on my lan that are connected with ACI leaf switches. I need to make them available on Golf. So, question is how do I send an IPv6 advertisement from my ACI to golf. I have collaps...
Hello, We have recently ordered new leaf switches for our ACI fabric. Version that we have recieved is:aci-n9000-dk9.14.0.3d.bin We need to downgrade this to:aci-n9000-dk9.13.1.1i.bin APIC: 3.1(1i) When I am trying to push this through ACI then I rec...
I have a Multi-POD setup with a server attached to leaf 101 (POD-1) and another server attached to leaf 202 (POD-2). Both of the servers are attached in same EPG. I have created a BD and assigned it an IP address which is of the same pool as the two ...
Hi All,
Just wanted to check if there is a way for us to support extended BGP communities. I need to give a route target value greater that 65535. I tried it but it was failing:
Saurav
Thanks for the response Nick. Fortunately I got it to work finally. I am not really sure on what was the fix as I just repeated all the previous steps and that worked. Probably I was doing something wrong earlier. Also, thanks for the document will k...
Hi Remy, Thanks for responding my APIC version is already running on 3.1(1i). So, I just need to downgrade the newly purchased leaf. One solution that I can think of is to change the boot sequence from 14.0(3d) to 13.1(1i) setup-bootvars.sh <target_...
How do I do this via Golf. I don't have any of my leaf interfaces connected to IPN routers. EPG 410 deployed is pointed to BD 410 and that belongs to a VRF A (standard deployment). How do I make servers connected to those EPG's available on IPN's in ...
