Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure ISE to restrict access to network devices for an AD group, limiting access to the security group to limited show commands but I am struggling with the authorization policy or how to configure the limited access.I have a poli...
I will appreciate some assisstance. I had site to site working at some point but not any more. Sice the devices are newly commissioned, i did a reset and applied config again but no joy. Kindly see configs attached. I cannot bring up the tunnels at...
I have set up site-site VPN on 5505s on 2 sites.I can ping outside interfaces from both sites but cannot get replies when I ping clients behind the 5505 from the ASA itself. I have also tried to ping from 10.x.x.x to 217.41.x.x and to 192.168..x.x bu...
I have configured site-site on 2 5505s. I am able to ping outside interfaces from both sites but pinging inside interfaces from the ASAs is coming up negative. Both sites are away from each other and I have not been able to go to site to ping from in...
hi all,I had a technical interview recently and seek opinions. The IT manager asked about loops, spanning-tree, firewalls and NAT. My questions is what your response would be to this scenario he put to me at the end.If a system is affected by a virus...
I have disabled Firewall on clients connected to both ASAs and tnnels are up and running, pinging from both internal addresses and getting responses.Surprising!!!
Portu,transform-set entry was missing from Romford config .. I noticed it from ASDM..The tunnels are up and running, thanks for your support.Cisco rules!!!Sent from Cisco Technical Support iPhone App
no response so far...Romford# conf tRomford(config)# manaRomford(config)# management-accessRomford(config)# management-access ?configure mode commands/options:Current available interface(s): inside Name of interface Vlan1 outside Name of interfa...
Portu,Thanks for r feedback. I have made entries recommended.At the moment, I cannot ping positively from either ASA to client connected to inside interface of ASA. I will not be able to ping from client until I am onsite tomorrow.Is there a way I ca...
