Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
Application visibility service, does not show any info on Cbar and NBar.
when I provision, I get message that Application recognition service not installed go to software management.
my issue is I don't have access to internet from the DNAC.
...
Hi,
I have three building in a single fabric domain. each building has two borders connected to the Fusion,
i would also like to have direct connection between the borders of three building, present they are connected through the Fusion.
Is it ...
Hey all,
should we stop the "initial configuration dialog"
it goes forward only after i say no, as shown below
the IOS-XE version is 16.6.4a
DNA version is 1.2.6
%INIT: waited 0 seconds for NVRAM to be available
--- System Configuration Dial...
Hi ,the license part number (L-LIC-CTIOS-1A) is available from both 5760 primary upgrade LIC and 3850 Primary upgrade LIc with same prices as wellMy Question is, if i purchase L-LIC-CTIOS-1A with the primary upgrade lic as L-LIC-CT5760-UPGUpg license...
Dear Jerome,
Thanks,
it's not yet implemented, i am still in the POC phase. to validate my design
I have found a solution to my problem. (some what)
i have one site with only one building (instead of 3)in the hierarchy, added all the border i...
Hi Jerome,
Thanks,
I have three buildings part of the same site.
All the 6 borders will be connected to the fusion(C6807),
All the border are internal+external,
See, i added all the border as part of the same building, i am able to configu...
check the connectivity between the DNA and the EDGE switch.
if you are using DNA connect to the fusion or in DC, advertise the subnet used for LAN automation in BGP prior to starting the automation from the border.
you can use one last ip from th...
Thanks Andi and Jedolphi,
The Issue is resolved now.
let me explain what was wrong, may be this will help others, who may face the same problem.
I had two interface from the DNA connected to the network,
the enterprise (enp9s0)was connected ...
Dear Andi,
My DNA is directly connected to Border switch on which i am running LAN automation
I am able to ping to the assigned IP of the new switch
Border_B#ping 10.128.0.2Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.128....
