Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am having some problems when deploying images via Multicast using Windows Deployment Server. All imaging sessions are failing after a few minutes. While troubleshooting this issue we tried different images and they fail also - unicast works fi...
Hi,Is switch 3 also IPBase? Connect a console to switch 3 and check the logs. I had this issue with one of my stacks. A license issue caused the stack to partition in two. When this happened I had two masters and the stack ports showed as down.Th...
I have seen the same thing when I had two set of controllers and one or two clients would move between the two areas served by them.Our Motorola wireless APs tunnelled client traffic to their controller so the wireless client MAC always came from the...
Hi,Is there anything logged to say the command was rejected? I had a similar issue and I could see a rejection notice when I checked the logs (show logging).What iOS feature set do you have installed? It may not support your exceed-action statement...
sounds like you are triggering a spanning tree topology change. Enable port fast on access ports should stop this.Sent from Cisco Technical Support iPad App
If the ip / MAC mapping is not in the arp table I often look for the MAC address in our DHCP servers lease list.Sent from Cisco Technical Support iPad App
