Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am experiencing a strange problem with my WS-C3560CG-8PC and a Meraki MV device.Set-up: 1 x WS-C3560CG-8PC, enabled for routing, service dhcp enabled, DHCP server is the switch and I am looking to relay the information to a 3P NAC solution. Whe...
Hi community, We are experiencing a high number of output drops on several port-channels connected to a stack of core switches at a branch site. Specifically connected to our wireless controllers (Aruba) which are the primary access medium for the si...
Hi community, We are experiencing an issue with regards to a specific flow we are trying to permit through and then back in through the ZBFW we have deployed. The flow is defined below. The flow is slightly unusual in that we are using TCP traceroute...
Hi community,
I have a query regarding traffic shaping when using the C3850-XS.
We have a 10Gbps connection between two locations. Between the two locations the connection will be configured as a 'trunk'. And we will be using Vlans/SVI's between ...
Community,
We are currently working on a project to integrate a pair of 4150 FTD appliances into an existing physical topology. We need to overcome a few challengers/hurdles with the design. I've attached the topology to better explain the issues.
...
Hi, @MHM Cisco World Please see configuration from switch below. 1. Camera is in Vlan57, DHCP server is the switch. Relay server is in Vlan10 (not shown) but which is routed from the switch. No firewall, etc between the Vlans it is just routing. hos...
Hi, Is this configuration still relevant in newer releases of code? we are running 16.3.8 We have also logged a TAC case with Cisco, waiting to hear back now
Hi Mark, I've ran the output of 'show tech' through the CLI analyser, nothing out of the ordinary came out of this analysis with regards to the software version we are using. Also, the Aruba controllers are 7030s which don't support 10Gbps. We only ...
Hi, It is both interfaces. However, one is considerably more than the other. I suspect this is because of the hashing we are using to load-balance the traffic over the two interfaces. xxxx#sh int gi 1/0/3 | inc dropsInput queue: 0/2000/0/0 (size/max/...
Hi, Apologies for the delay. The ZBF that I created the post for is deployed the other side of the world so I have had to simulate the configuration in our lab. I've managed to do this now and have the captures. The trace is being executed on a Thou...
