Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So my setup is a VPC with 5Ks and with each 2K with uplinks to only one 5K. Is it possible for servers to port-channel to both 2Ks for a VPC? Or is that only possible if the 2Ks have a VPC back to the 5Ks?
Been searching over but haven't found a solution.Basically, I want to do a static nat only over a VPN site to site tunnel.So our lan is 10.0.0.0/22 and it will be static nat'ed to 172.16.0.0/22 when going over the vpn. I want a one to one static nat...
I am trying to enable SSH, however the commands for Crypto are not available.Is this because the switches are stacked? Do I have to unstacked before I can generate an RSA key and enable SSH?Any help would be appreaciated.Thank you.
My edge router is pegged at 80% and interrupts at 8%. None of the processes show up as being high. What is the next step to troubleshoot this? How do I find out what is using all this CPU? below is the show proc cpu sort command. and show proc c...
Is there a way to find out which policy a peer has agreed upon? I know it takes the strongest encryption level. I tried all the show commands from:show crypto isakamp *and none of them give me the information I need. I was only able to find out doin...
That only works after I started a communication from me to them. If I dont, there's no nat translation yet. And if the other side tries to reach me first, it would fail, unless I initiate first. Which is something I want to avoid.
Also the interface for outbound traffic is: 5 minute input rate 627000 bits/sec, 182 packets/sec 5 minute output rate 493000 bits/sec, 201 packets/secWhich doesn't suggest alot of traffic flowing through. There is a huge ACL and FW inspection is on...
