Level 1
Level 1
Member since ‎02-02-2012

User Statistics

  • 54 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
10 Replies
5 Replies
1 Accepted Solution
20 Replies

User Activity

So my setup is a VPC with 5Ks and with each 2K with uplinks to only one 5K.  Is it possible for servers to port-channel to both 2Ks for a VPC?  Or is that only possible if the 2Ks have a VPC back to the 5Ks?
Been searching over but haven't found a solution.Basically, I want to do a static nat only over a VPN site to site tunnel.So our lan is and it will be static nat'ed to when going over the vpn.  I want a one to one static nat...
I am trying to enable SSH, however the commands for Crypto are not available.Is this because the switches are stacked?  Do I have to unstacked before I can generate an RSA key and enable SSH?Any help would be appreaciated.Thank you.
My edge router is pegged at 80% and interrupts at 8%.  None of the processes show up as being high.  What is the next step to troubleshoot this?  How do I find out what is using all this CPU?  below is the show proc cpu sort command.  and show proc c...
Is there a way to find out which policy a peer has agreed upon?  I know it takes the strongest encryption level. I tried all the show commands from:show crypto isakamp *and none of them give me the information I need. I was only able to find out doin...
Community Statistics
Member Since ‎02-02-2012 09:18 AM
Date Last Visited ‎08-18-2017 04:03 AM
Posts 54
Total Helpful Votes Received 5
Helpful Votes From