About wilsonbolanos

wilsonbolanos · 03-02-2015

Scan:FTPEndpoint: *.*.*.* (Public ip)Vulnerability: TCP timestamp responseSeverity: 1Certainty: Confirmed DESCRIPTION The remote host responded with a TCP timestamp. The TCP timestamp response can be used to approximate the remote host's uptime,...

wilsonbolanos · 09-12-2014

We have Cisco ASA 5520 ver 9.1 and we created a L2L Vpn tunnel with another company. We ran into a problem while printing via AS400 and we new it was a port that was being blocked. The reason we new it was a port, is that when we allowed everything...

wilsonbolanos · 06-22-2013

Cisco GRE Tunnel with IPSec. Connection is lost every 4 to 5 hours and has happened for the last 7 days (where I loose ping and telnet capabilities to router for about 15 minutes) Cisco router 1841, Version 12.4(11)T4. I was lucky that I was telnete...

wilsonbolanos · 04-15-2011

I can get voicemails if phones calling within CME call each other and leave messages. If I call from Call Manager to CME, after the 4th ring I hear nothing instead of the voicemail option. Calls between Callmanager and CME work fine, its only when ...

wilsonbolanos · 04-12-2011

When first login in via the web page. When going to Configure menu and choosing CUCME to enter it manually, I get:Error: Login to CUCME failed with the new values. Check the new CUCME configuration and enter the correct values.hostname: 172.23.0.1w...

wilsonbolanos · 09-12-2014

192.168.0.89 us172.16.13.45 them when I was doing my capture capin inside host 192.168.0.89 host 172.16.13.45, I probably should have reversed them to capture the port 9100. basically we were just capturing the port 23 telnet to the AS400.

wilsonbolanos · 09-12-2014

We did do the vpn-filter value is what we have. on the ASA. but my question is when we were allowing everything in we could have seen 9100 being hit (although we did not know it at the time of troubleshooting). What command would have shown this p...

wilsonbolanos · 06-26-2013

Do you have to change it on the hub and the spoke or will it be ok to just change it on the spoke?

wilsonbolanos · 06-26-2013

Thanks Rick for your help. The ISP had assigned our static IP to someone else as well. Is 120 seconds the default? What is best practice? I think we have it set to default of lifetime of 120 seconds. How would we change it to a higher number of s...

wilsonbolanos · 06-24-2013

The hub router was up and operational since I was VPNed to it from home. The other spoke sites that connect to the hub were also up with no problems. Wug would have notified me of outages at other sites, but the only site that goes down is this on...

Member Since	‎09-14-2009 09:40 AM
Date Last Visited	‎04-18-2019 01:05 AM
Posts	25

User Statistics

User Activity

VMS Vulnerability Alert 5520 ver 9.1(5)

VPN Tunnel L2L Port question

Interface Fa0/0 on Cisco 1841 fails after 4 to 5 hours, no pings allowed to that external interface fa0/0, deb ip packet detail output crypto map check failed., proto=47

CUCM 7.1(3) sip trunk to CME router with CUE 8.5.1 no voicemail

CUE 8.5.1 NME-CUE web page setup no setup initialization and error: Login to CUCME failed

192.168.0.89 us172.16.13.45

We did do the vpn-filter

Interface Fa0/0 on Cisco 1841 fails after 4 to 5 hours, no pings

Interface Fa0/0 on Cisco 1841 fails after 4 to 5 hours, no pings

Interface Fa0/0 on Cisco 1841 fails after 4 to 5 hours, no pings