Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I am replacing the existing firewall with Firepower series FPR 4110 model.
I am getting issue in making interface up, Also after going through the config guide i have below questions
1. Is all the features are license based, including maki...
Hi Team,
I am facing one issue in leaking the routes between the L3 outs configured in different Tenants. Below is the description in detail
1. I have one L3 out in Common tenant , which is not binded to any EPG
2. I have second L3 out in Tenant ...
Hi Guys
I am implementing the WCCP over Cisco 2911 with SRE module
I have hub and spoke network design with all the spoke routers connecting to hub router over DMVPN
I have enabled the wccp on all the spoke routers and on hub router with 61 and 62...
Hi ,
A very good afternoon to all.
This is Rajhans here , and have one query regards to AP 2702. Following is the challenge that i am facing now. I am implementing Wireless RAP/MAP architecture first time.
I have two AP of 2702 Series and a WLC 55...
Hi Team, I am running in one issue. Few days back bought WLC 5508 for my customer who is currently running Aruba. I powered on the WLC which is in HA and setup the basic parameters like , DHCP Server IP under the management interface and added one R...
Hi Marvin,
Thanks for the reply.
Actually you have hit the basic point which i have not understood till now.
What is ASA firepower 4110 and what is only firepower 4110. Why there is a ASA word here
Because there is no ASA CLI syntax , GUI , ASDM ...
Hi ALL,
The issue has resolved.
Sandeep, I have enabled the suggested settings and it worked post reboot of AP.
I choose the mode as flex connect + bridge
Also the AP 2702 is indoor AP with omni directional antenna, Hence the space between the RA...
my branch 2 also has dhcp server. All other APs of location 2 which are configured in flex connect mode are receving the ip addess from that server, but only RAP and MAP users are falling on location 1 dhcp server
Hi,
Thanks for the reply.
i tried the same option but its not working.
Also i would like to highlight one option, which initially i thought not required.
My wlc is at location 1 and my APs are at location 2.
when i run the debug i found that ...
