Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have one Cisco 6509-E switch with WS-SUP32-GE-3B supervisor engine. Now i want to upgrade my supervisor engine with VS-S2T-10G .
At present i have only one WS-SUP32-GE-3B Sup card connected to switch but now I have to install 2 new SUP-2T ...
Hi All, I have one laptop and mobile (with internet) and one router. Now I am connecting to Router using LAN cable and also connecting laptop using wi-fi hotspotwith mobile. I am able to connect only single connection (Either LAN connection or Wi-fi ...
Hi All,I have one cisco 4507R-E switch with SUP 6-E. When I power UP switch. switch is boot with primary sup. Secondary module shown as "Disabled".How can i enable secondary module?
I have cisco 2960G switch. I got below error message on switch at some interval. "Memory on switch has insufficient capacity or is malfunctioning."Switch model no: WS-C2960G-24TC-LSW version: 15.0(2)SE2SW image : C2960-LANBASEK9-M
Hi Azeem, I had faced same issue in past. Please check the end device connected to the AP are affected by virus or not. In my case, I found lots of viruses on end devices connected to wireless AP. After removing the virus all operation became no...
I am getting flapping logs on cisco switches.switch log for reference:Sep 10 14:18:49.974 ist: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.bc62.cb51 in vlan 1 is flapping between port Gi1/0/25 and port Gi1/0/1
