Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, Recently I got an opportunity to perform POC with Cisco ISE (2.7 Patch 4) and Aruba Wireless AP (IAP) to perform 802.1x EAP-FAST (machine + user) authentication followed by Posture Assessment on Windows 10 Machines (installed with AnyConne...
Hello All, Recently I got an opportunity to perform POC with Cisco ISE (2.7 Patch 4) and Juniper EX 2300 switch to perform 802.1x EAP-FAST (machine + user) authentication followed by Posture Assessment on Windows 10 Machines (installed with AnyConnec...
Hi,I will be setting up Full Tunnel SSL VPN using my asa 5520 as a vpn server.After reading documents I know that NAT must b disabled on ASA for the pool addresses.Can anyone explain te exact logic behind this.Regards.
Hi,I will be setting up a site to site vpn between our two branch offices using ASA 5520 (VPN Gateway) at both locations.Both of my ASA's outside interfaces are configured with Static Public IP address which I will be using for vpn peer identity.What...
Hi,Some say the vpn peers authenticate first and then start the process of building the ISAKMP tunnel.However most book/blog-posts say authentication happens in 5th & 6th packet using the encrypted hash of the pre-shared key.Is this right?So what is ...
Hello All, Recently I got an opportunity to perform POC with Cisco ISE (2.7 Patch 4) and Juniper EX 2300 switch to perform 802.1x EAP-FAST (machine + user) authentication followed by Posture Assessment on Windows 10 Machines (installed with AnyConnec...
Hello All, Recently I got an opportunity to perform POC with Cisco ISE (2.7 Patch 4) and Juniper EX 2300 switch to perform 802.1x EAP-FAST (machine + user) authentication followed by Posture Assessment on Windows 10 Machines (installed with AnyConnec...
Hello All, Recently I got an opportunity to perform POC with Cisco ISE (2.7 Patch 4) and Juniper EX 2300 switch to perform 802.1x EAP-FAST (machine + user) authentication followed by Posture Assessment on Windows 10 Machines (installed with AnyConnec...
Hi,Thanx for taking your time and helping me out.I was really confused about the process of SSL VPN and this has helped me a lot.Just one question: Does it add any header before original IP header to encapsulate like esp in IPSec.Regards.
Hi,Thanks.I have couple of queries.I understood that Cisco Anyconnect will assign my laptop a private IP address from the VPN pool after successful authentication.But in reality I am connecting the VPN server through my local ISP from home.So how doe...
