Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I have a CBT (Cisco Broadband Troubleshooter) v 3.4 apllication installed in our network. However, it can't read MC20x20 Linecard in the spectrum analyzer for the example. I read in the documentation that is supported. In our system, it only...
Dear All,anyone have hitting by this bug?because i have this bug in several card when upgrading from SCC7 to SCG5.It will be a problem when your line card is not under warranty. How can cisco resolve this bug? because we need to run SCG version to us...
hello all,I use CMTS 10012 and IOS version 12.2(33)SCC7.anyone have an experience with these error log message?Jul 12 14:17:11: cr10k_docsis_xform() Err: xform failed C8/0 T=1044 P=0xC0D4F4D4Jul 12 14:17:11: -Traceback= 4066CB74 4066D4CC 4065A874 406...
Dear all,I want to ask about Cable broadband, using UBR10012.I have try to use DS Resiliency (Using cable rf-change-trigger command with cable resiliency ds-bonding) in IOS SCG3 version and wideband resiliency in IOS SCC7 version, but i can't find a ...
Dear all,I want to ask about Cable broadband, using UBR10012.I have try to use DS Resiliency (Using cable rf-change-trigger command with cable resiliency ds-bonding) in IOS SCG3 version and wideband resiliency in IOS SCC7 version, but i can't find a ...
I have try and find that the CBT 3.4 can't read MC20x20 in SCG/SCH IOS version, but it can read in SCD version. let me know if someone can use CBT3.4 and read in SCG/SCH IOS version.
Hi,I'm also had this error message. What is the explanation about it Jul 4 09:25:27: %PLATFORM_UCAST-3-LB: PI<->PD handles out of sync for Adj 192.168.204.10 LB-Traceback= 2DC480 2DCB94 16611DC 15CBAC0 15CDD14 166216C 1671F68 1665E04 16625C0 1658C6...
Yes, it works.It will split. 2 when you have 2, but remember, it is a rendundacy power module. So, you should aware when 1 power had a problem.But, if you had full card, i think you will have power consumtion more than 2400 W. Last month, I upgraded ...
Hi Startx001,You can check use command show environment and look your power consumption. If it's less than 2400 W *please note, your power will be average if you have 2 UBR10-PWR-AC.Make sure if you sum Power A and B will be less than 2400 W.If it's ...
