Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
First of all, thank you for taking the time to read this.....We are trying to add an IBM P770 to our Cisco MDS 9000 Fabric Switch. We've set the port to Fx mode, trunking off, rate-mode is shared. For some reason the port remains in the "initializi...
Another weird one popped up the other day....We were replacing 7 autonomous 1231 AP's with 7 3600i's. Once we replaced them, the AP's were up and running. Users were connecting to them with no issue. We started receiving reports that all of our ha...
Currently, we have two regions that have 5508 wireless controllers on 7.5.102.0. Both regions are in an AP SSO configuration for redundancy. Each active controller has a 150 license on it. I do understand that when the active controller has an iss...
We are currently running HSRP, as our redundancy protocol, on our routers. Our site has two WAN connection. One is an MPLS, and the other is a VPN GRE IPSec tunnel. We have Policy Based Routing that routes certain traffic over the VPN tunnel, and ...
We went through an upgrade from 7.4.100.0 for all of our WLC's this morning. One of the interesting features, that we wanted to take advantage of, was the BYOD profiling that the release notes talk about. I'm going through the controllers and see t...
Mark,We were seeing the same thing! Our resolution (not really a resolution, but more of a work-around) was to turn down the alarms. I do see that there is an enhancement request for this (CSCtd34834).
@campbech1,Ironically enough, we're also implementing ISE within the next few months! Let me know how your ISE rollout goes! As far as code 7.5.102.0 goes, we only ran into one issue. It's a known issue(CSCud68413), which causes any controller, th...
Scott, thanks for the reply. The new 3600's do not have their interfaces trunked, and are in FlexConnect mode. Looking at the autonomous AP's, they didn't have their interfaces trunked either. All switchports are access ports. It's just really o...
