Hi All,Can we restrcit the bandwidth utilzation for Microsfot Lync via using QOS as it is creating problem by using more bandwidth. If we can kindly suggest the procedure.Need you help on urgent basis.Regards,Bikas Pandey.
Hi All,I am facing with issue with the bandwidth . We have various project who have remote vpn. Users are logging in the customer network and downloading unwanted thing which is crossing the bandwith and creating issue with the other project. Can you...
Hi Grenfield,I have some confusion regarding your question. As i know when you configure the cisco anyconnect vpn , you always define a pool of ip address configured in the firewall itself. So you need to create pool of the ip address and assign thos...
Hi Mark,You need to start troubleshooting from IKE phase 1 then Phase 2.If you are confirm that there is no issue then you can use the below command to check what is happenning : -packet-tracer input LAN protocol souce-address protocol-type destinat...
Hi Ross,The default behaviour of the VPN client software is that they will tunnel all the traffic, including your LAN traffic. If you want to access you local LAN even if you are connected with VPN, you need to ask the client to enable local LAN. Th...
Hi Christopher,If i understood well than you want that your VPN traffic should not be translated. If that is the case you can do it with nat exemption.Below is an example of how you can use nat exemption:-ciscoasa(config)# access-list NAT_EXEMPT ext...