Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I’ve been using a Cisco ASA 5505 Security Plus bundle for two years now without any problems. My previous Internet Service Provider was routing the external IP I was leasing directly through to my internal network without NAT which my ASA 5505 was wo...
I’ve been using a Cisco ASA 5505 Security Plus bundle for two years now without any problems. I recently changed my ISP to Verizon FiOS (which is providing me with 25 Mb bandwidth at a fraction of the cost of my old T1) which is set up to provide 5 S...
Hey everyone,I'm configuring an ASA 5505 with the Security Plus bundle running Version 7.2(4) Software. I'm trying to get my DMZ setup correctly. I have successfully got inbound access to my DMZ from my inside interface working so I can remotely ma...
I run a very small web, email and dns hosting businessmen and had been running a PIX 506E for several years with no problems. Since it had finally reached end of life I bought an ASA 5505 with the security bundle. I'm not a firewall expert by a lon...
I’m unable to access my mail server using authentication from outside the network. I’ve disabled fixup using the “no fixup protocol smtp 25” command, performed a “clear xlat” and a “write memory” command; but so far nothing has worked. I’ve double ...
I hope some of this helps. Several people have reference adding a Switch between the ONT and ASA because of the way Verizon FiOS implements subnets; but I'm not sure what kind of switch or how to configure it. Thanks again for your continued attemp...
I'm getting FiOS Internet via Fiber Optic so, as I under stand it, I get five IP from the Optical Network Translator (ONT) which in turn provides me an ethernet cable out which I can plug into a router, a firewall or even directly into a computer if ...
I changed the outside interface to 96.241.175.102 as suggested issued a Clear xlat and clear arp commands. I still have full outbound connectivity (indicating that the 5505 can use the new IP address); but I still can't reach any internal resources f...
When I got into my Verizon router set up it shows that I have TWO connections. One is the external Ethernet "Broadband"connection and the other is "Network (home/Office) connection. Below are the configurations for both of these two connections. I no...
I just got a call back from Verizon. This tech said he thinks he may have identified another "known issue" (they seem to have a lot of those) which has caused similar problems with devices. He requested I let you know that if the ASA 5505 can be set ...
