Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. We have just installed our two first Nexus 3548 switches in our Catalyst environment. We want to set up a vPC domain between the Nexuses, to use for connections to storage and other equipment.I have read the guide at http://www.cisco.com/c/en/us/...
Hi.I am helping a customer with setting up multiple SSIDs on their wireless APs. I have created two SSIDs which use different VLANs. There is also a third VLAN for management. Everything works fine when connected to a trunk port on a Cisco switch. Th...
Hi.I am working on setting up a new WLAN infrastructure. I have set up different SSIDs connected to different VLANs, in the AP.I also want to use Windows NPS for authenticating users on the different SSIDs, with different authentication methods based...
I can use mgmt0 without problems, and it is currently used for both management and vpc keepalive. But there is also a physical mgmt1 port on the switch. However, the only interface available in NX-OS is mgmt0. If I try to configure mgmt1, I get an er...
Thanks.I moved the management IP to mgmt0 and changed vrf to management for the keepalive link, and now it seems to work correctly.However, I was thinking that maybe it would be good to use a cable directly connected between the mgmt1 interfaces for ...
We are not using the management ports for management, but an ordinary Vlan Interface in the default vrf, as seen below. We can of course change that and instead use the mgmt0 port if that is the best approach. vrf context managementvlan configuration...
I was just in contact with Cisco support about this, and they confirmed that it is not supported, and not on the roadmap. It unbelieavably stupid and I don't understand why.This feature is available in the most basic Catalyst switches since 10 years,...
