Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, Im using Cisco 5508 with 7.0.220.0 code and I just wanted to know if its possible to disable some data rates to a specific group of APs and not affect the rest of the APsAnother question is about almost the same thing but related to W...
Hi all, I have a question to you all.I have to set up a new wireless infrastructure on a large warehouse. I have a 5508 with 15 APs 802.11b/g so far.A new area of the warehouse (indoor) is ready to be used with new wifi devices and I want to isolated...
Hello all, I read some papers about QoS and Im just wondering if someone could give me a hand.The thing is that I have to implement 30 switches with QoS to connect to a lot of Cisco IP phones.The switches are Cisco 2960S with code image "C2960S Softw...
All, good day. I have a bug reported (CSCsy23704) for the H-REAP functionality. This sunday I will perform an image upgrade to try to solve this issue.What would it be the best image to go for?.After the upgrade, what will happen with the APs?, shoul...
Hello everybody, Im consulting you because Im implementing a new AP outside my office.The new AP is configured to use HREAP but it doesnt register with the centralized WLC.ping connectivity is OK between each other.This is the log on the AP:*Mar 12 1...
Thanks for your response David.One of my ideas and that I want to validate with you all, is using 802.11n 5 GHz band AP, maybe Cisco 1260 with AIR-ANT5160V-R for this new area. I think that with this I will "isolate" the operation, since existing APs...
I have one question. Using this type of switches (2960S) which dont have input queue involves that I should use policed traffic over the ingress queue and expedite output queue?.Whats is the best practice for this kind of devices?, taking into accoun...
Im performing in a few minutes the procedure before explained by Osita.This is the output you requested.THANKS IN ADVANCE!!AP-Cican-1#sh versionCisco IOS Software, C1240 Software (C1240-K9W8-M), Version 12.4(21a)JHB, RELEASE SOFTWARE (fc1)Technical S...
The WLC has two management interfaces, .3.165 and .3.166Ping to both addresses is OK.The problem is that when I initialy config the AP, it doesnt join to the WLC, but after a normal reboot (reload now command), the AP did join the WLC.After a few min...
Thanks Scott!!!.I have one more question (a lot actually!!).What if the primary WLC is out, the APs will register to the backup WLC and download a new image?. This process is automated or manually?.Again, thanks for your help.
