You could either install an individual L3 NAT router in front of every device to test and present a valid 'external' IP address which your software would connect to.Or you you could use L2NAT, where the end devices all have the same IP address and yo...
Yes you can connect your servers directly to the N5548s at 10Gb. The N2Ks when connected to upstream N5K/N7Ks are managed from those devices. You need to verify that you have the correct 10Gb interface types on both the servers and the N5Ks.Sent from...
R1 and r4 need to run ospf and learn the route to the tunnel destinations dynamically. So you need to advertise the connected networks on both R1 and r4 into the ospf process and confirm that R1 and r4 have routes to each other.When the tunnel comes ...
If you are trunking to the access switches then you will get TCNs when the access layer switches are disconnected. If you don't need multiple vlans for your end users in this location then convert the trunk from the upstream switch to an access port ...