About Yasien Adams

Yasien Adams · 07-25-2013

Hi All,Does anybody know if API docs exists for UC540 and UC560?Customer planning to integrate ERP solution with existing UC540 installation.ERP developer (Hansa World) asking if API docs are available?ThanksYasien

Yasien Adams · 04-18-2013

Can someone please explain what this is?000188: Apr 18 10:17:12.233: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for CCSIP CCB Pool. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x82A46F64z 0x802BE364z 0x802C0FD...

Yasien Adams · 03-08-2013

Hi,I have attached a 7916 Exapnsion Console, to a 7970 IP Phone.In CCA when configuring the phone, it only shows an option to choose 7914 or 7914x2 for the connected expansion console.I tried going through CLI, then changing the type 7970 expand 7916...

Yasien Adams · 03-06-2013

Hi All,I have the following call routing setup on a UC540.Incoming Call => AA ext.298 [caller is greeted with custom greeting] => No Option Transfer to Blast Group ext. 511 .....now the caller waits to be answered by a representative.What I would lik...

Yasien Adams · 01-28-2013

Hi,I recently added a T1/E1 voice card to our UC540.Its connected to a Optus voice service, which is being provided through a Telstra Megalink Service.The NTU is connected to the VIC.I configured the VIC is PRI, and I get an active connection.I also ...

Yasien Adams · 05-25-2016

Hi hard to tell from those shots. I would break the VPN config on both sides, and re-do again with the wizard. Delete all reference to each site in the ACL lists. The wizard should re-create the VPN tunnel with appropriate NAT config. also, what are...

Yasien Adams · 05-25-2016

do you have VPN config running?

Yasien Adams · 05-25-2016

Hello julifdela, Did you end up fixing this problem? All you needed to do was configure your ACL's to first deny the traffic between the sites, then permit it. (no NAT)

Yasien Adams · 07-01-2013

What about wired users?Can they access the internet?Yes you definitely need to configure NAT, and apply inside to wireless and wired interface.

Yasien Adams · 06-27-2013

Hi,Your ACL should be have a standard deny all, and then you just open the ports that you want to be exposed to the outisde world.access-list 101 permit tcp [FROM] [TO] eq [tcp port number]access-list 101 deny ip any any

Member Since	‎12-13-2010 09:34 PM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	99
Total Helpful Votes Received	20

User Statistics

User Activity

API Documentation

Looks like a memory fault

7916 Expansion Console

Incoming Call Queue and Management

T1/E1 Configuration

Hi hard to tell from those

do you have VPN config

Hello julifdela,

UC540 Internet connectivity issue

Blocking ports via ACL