hay friend    you could be hitting a bug with old versions of mobility express   try to update to the latest version in 8.5.140   and see if it helps with the flapping issue   ... View more

any updates thank you ... View more

Good morning    hope you had a great weekend   sorry for the confusion the remote engineer had things mixed up and after further negotiation this is the update !    there is 2 sites  SiteA telco is not sending caller id (cisco 2901) i have called telco and requested it to be enabled SiteB Telco is sending caller id and yes after 1 ring as shown on the analog phone (cisco UC560)     i have attached the config of site b now and the debug requested including show run | s voice-port 0/2/0 and show inventory   site B: this version of uc560 has the cptone SA set to bellcore and as you told me SA are using  DTMF  i have tried cptone sa and using show voice port 0/2/0 i sow that the caller id mode is bellcore i have changed it now to Cptone BR and checked now the caller id more is etsi dtmf   thank you for the support    have a great day ... View more

yes if i connected an analog phone directly to the line i see caller id    if the string is showing time then maybe bellcore is incorrect    since every google i sow online says Saudi Arabia is using Dtmf   i am going to switch to CPTONE SA and send you a newer debug          ... View more

its  VIC2-2FXO  ... View more

hello this is the config under fxo port please note that we have an old panasonic phone connected to the same fxo and it is showing caller id so there is caller id !  voice-port 0/0/0 trunk-group ALL_FXO supervisory disconnect dualtone mid-call supervisory custom-cptone voice supervisory dualtone-detect-params 1 timeouts call-disconnect 5 timeouts ringing 5 timeouts wait-release 5 timing hookflash-out 50 connection plar 1000 caller-id enable ... View more

thank you for the reply   please check the attached debug ... View more