Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody. I faced a problem which is not standard for me. Some VPN clients on Anyconnect stopped connecting, swearing that the certificate was not correct, while others connect without problems. I installed a self-signed certificate and a certif...
Hi everybody.
I was tried to convert asav.vmdk files. There are two files first files is boot.vmdk second is disk0.vmdk and I was converted both files to qcow2 format. But Don't know how to install this ti files right on gns3.
please to help t...
Hi. I have some issue with cisco vpn client on windows 7 64-bit. I have successfully connect to vpn server, can do the ping the needed server in lan can connect to him via telnet to check connection but when I to try realy connect via ssh via ma...
I have a problem with latest Anyconnect Mobile clients, on any device(iPhone,PC..) I have this error message.
Anyconnect cannot verify the VPN server : fw01.cert.loc
Certificate does not match the server name
Certificate is from an untrusted source...
Hi everybody. I have some issue with cisco prime 2.2 I configured cisco switches for snmp v3 and add in cisco prime
I have see only reachability of devices. I need too see cpu utilization memory utilization, Interfaces traffics statics bandwidth, ...
Thanks to all who try to help me. The issue was solved. The issue was on the client side and was a client-side certificate. The client's certificate not showing the right version. Clear it and open it in another browser That's all.
this is part of config for ssl VPN:: Hardware: ASA5525, 8192 MB RAM, CPU Lynnfield 2394 MHz, 1 CPU (4 cores)ASA Version 9.8(1)5!hostname ASA-1domain-name asa.locnamesdns-guard!interface GigabitEthernet0/0channel-group 1 mode activeno nameifno securit...
The version is the same for the clients who connected via Anyconnect and is not connected.But it's interesting that I have created new certificate and do trust point to outside not working clients which they connect they are not showing a warning w...
I configure the self-certificate via the cisco guide. this certificate doesn't import to client laptops or PC. I never do that because everything works without it.Could you tell me which part of the config you need to show? and which dart file?
