Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Why don't you assign a different static IP to SVI Interface VLAN1, NAT inside, remove IP unnumbered and have it on the same subnet as the firewall's interface.
Set the default route on the firewall to point to the SVI's IP.
Also set an ACL for all su...
Hi,I have a Cisco AIR-CAP1602I-Z-K9 access point and trying to join it to a 2504 WLC but cannot. Is this setup possible? From the software release guide Release 7.0.220.0, I cannot see the 1602 AP listed.Please advice.CheersJohn
