We have hosts in Primary and Isolated Vlan on both vDS and behind N5K.Private Vlan problem but can't tell if it's on the VMware vDS side or physical Nexus 5500.Current problem is VM in Primary Vlan on vDS can not talk to VM in Isolated Vlan on diffe...
Nexus 5548 with no layer 3 module. Want to manage the device via 10.122.122.5 9 (inband) and 10.122.123.58 (out-of-band)Currently i can get to the device using 10.122.123.58 via management vrf but can't get to 10.122.122.5 via default vrf.A couple o...
I am considering configuring UCS to use TACACS but can't find any documentaion to suggest if the UCS would fallbackto Local when TACACS fail. One would assume that it would so any link or pointers would be appreciated. Thank you.
Traffic is fron Inside to Outside. When users from Inside connect to a host on the Outside with destination IP of 10.244.87.1, the pix should translated to 10.244.86.1. The documentation said you can use static for Lower to Higher security. This ...
I have IAS running on W2k3 Active Directory. I have tested sucessfully set up 2 group of users called Level1 and Level15 logging in to routers. Level1 gets privilige 1 while Level15 gets 'enable mode'. What I want to do next is set up IAS so that ...
Isolated Trunk is for case where you have a switch that do not support PVLAN. Quite a few examples of this use case. This is one http://blog.ipexpert.com/private-vlan-trunks-pt-2-the-secondary-isolated-trunk/ Anyway, gave it a try. Didn't work and al...
Attached has requested information.ESX hosts connect to FEX which connect to N5K.Port 4,5,12,13 on each N5K connect to FEX 2232 NIF.The 5 ESX hosts connect to port 1,2,3,4,5 on the FEX HIF.The last config change I added was "system private-vlan fex t...
My problem was upstream so above is working fine.You can manage the N5K via both default and management vrf without Layer 3 module. Pending static route in the default vrf is just cosmetic. I manage the N5K via default vrf and the management vrf is...
Oh, Thank you for the information. Since console acccess means command line only.Am i right to suggest that one should know how to make changes and back out via command lineas the Web GUI won't be available when TACACS goes down?
Hi there,We are looking at seting up UCS on TACACS. The one question I can't find in the documentation is what happens when TACACS server fail?One would assume that it would fall back to Local but I can't seem to find this information.Regards - TN.