Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi If you have only 1 public address can you NAT and PAT to 2 servers/PC's on the same port or do you need more public addresses.For example to FTP servers on the LAN with a single IP address on the outside.Richard
HiMy company has requested me to install a switch on a WAN link.They requested I configure a loopback address.I configured the switch vlan1 with an ip/mask and no shut it.The WAN link goes through the switch no problem.When I configure an Loopback ad...
Hi,Can someone point me in the right direction,thanks in advance for any help!!I'm not getting DNS resovled and I can ping from inside 10.0.0.2 to a WAN IP.One think that is also puzzling me is that I can ping a WAN IP from a workstation(10.0.0.2), b...
Hi,I have a router for my CCNP studies, I'm going to put a ADSL card in the router but will need a IOS image upgrade as I'm running 11.2.I need 12.0 or higher.I have a guest login to cisco, but I not authorized to download any.Where or how can I get ...
Hi All,I have a cisco 2611 and thinking of buying a CISCO WIC1 ADSL card.My ISP uses PPPoA will I be able to install this card in the router and connect.Also I have IOS 11.2 will I need to upgrade to 12+Thanks in advance for any help
Ok,So when you start VPN wizard on the PDM,you select the type of VPN in this case site to site, you then have a option to select inside/outside.Whats the difference between too.If you select inside does this give hosts on the remote network full acc...
