Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We have dmvpn configured to multi nodes from our Office
interface Tunnel2 description MULTI-POINT GRE TUNNEL for BRANCHES ip address 172.26.3.1 255.255.255.0 no ip redirects ip mtu 1400 ip nhrp authentication dmvpn ip nhrp map multicast dynam...
Hi All,
Can we check with below capture there is no issue from ASA side.
87: 19:43:11.918363 802.1Q vlan#161 P0 10.160.21.212.49219 > 10.143.227.2.389: SWE 3625561743:3625561743(0) win 8192 <mss 1460,nop,wscale 8,nop,nop,sackOK> 88: 19:43:11.963664 ...
Hi All, Can we create inner vlan as an outer vlan of the qinq vlan for customer internet services, we have core -huawe & access cisco as the below configdHuawei>di cu int gi 0/0/0.3005[V200R003C00]#interface GigabitEthernet0/0/0.3005 qinq termination...
Hi All,I have cisco 36xx connected to l2 node,we have the servcies on the bridge domain, but not on the evc of mpls;Please find the below config of bridgedomain & EVC. (Internet )BRAS -> Huawei DX(57xx)-> Cisco 36xx->CTS(3rd party) EVC CONFIGURATION:...
Hi All, While i m doing for the remote ldp formation between this devices of cisco 3600 & huawei 5700,attached the configs of these 2 nodes.what could be the possible reason for this..witch(config-router)#do sh mpls l2 vcLocal intf Local circuit ...
Hi,4500-x doesn’t support MPLS L2VPN &l3vpn, isis-bgp & te functionsou may consider ME3800x ( ME 3800X-24FS with 24 Gigabit Ethernet SFP ports and two 10 Gigabit Ethernet SFP+ ports)ME3800x is similar to 4924-10GEIf 12 Numbers of 10G ports are requir...
Hi Akash, we can see it by " sh xconn all" the Virtual circuit ID "S to be matched,for end to end traffic ,its detailed conectivity will be known by sh xconn ID detail Thnx/ Kumar
Hi Nagendra,This is directly connected switch for which i ma trying to establish a remote ldp,sh mpls interfaces, states the tu1 as down, is there anything wrong in hereSwitch# show mpls interfacesInterface IP Tunnel BGP Sta...
Hi Nagendra,Couldnt find the neighbor & the ping isnt successful, but there is discovery & binding-local found in;can you suggest further please.Switch#sh mpls ldp discovery Local LDP Identifier: 10.50.2.2:0 Discovery Sources: Interfaces: ...
