Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I'm working on a solution to dynamically change ISP core routing based on the quality of one of backbone links. I'm trying to use IP SLA to monitor the MOS value, since the ISP is only transporting VOIP traffic. Once MOS value is lower than t...
Paul,I believe that IOS is not capable of doing that, like Ivan posted long time ago.http://blog.ipspace.net/2007/10/you-cannot-start-telnet-session-from.htmlIf possible, please upgrade to 15.X, which fixed some bugs about eem.
I can assure you EEM on IOS can initiate telnet session without a hitch, but on IOX, still struggling to find out the workaroud. proc remote_cmd_telnet { remote_host username password prompt_expect clist } { # this function will carry out each com...
if you enabled "address-family ipv6 unicast" or "address-family ipv4 unicast" in ISIS, IPv4 or IPv6 must be turned on inteface level, otherwise you will get the message like this" Interfaces supported by IS-IS: Loopback0 is running passively (pas...
Hi Joe,The software you mentioned here, IDEEM, can not to be googled, and the link is redirecting to a weird website, Could you please provide the download link again ?
