Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i'm trying to configure FIREWALL load-balancing via ACE in L2 mode, andthere is something i don't understand."client 1" ping "client 2", trace shows - the ping crossing MSFC - arriving on ACE via VLAN 10 - existing via ACE VLAN 11 - ping reach the...
i cannot have access on ACE console portusing 'session slot 4 processor 0', i can see that no special cfg for line console is donei used another ACE module with same terminal (secureCRT 5.0.5) and now i can see script when ACE reload but i can't type...
Hi Roland,
i have made the setup you explain, it is working as expected but i still have a convergence problem.
When i cut one of the Po on N7K-50 (Po1 for example), it take around 30s for the data traffic to switch to the other Po going to N7K-65 (...
Hello,as i know, there is no others ways.You can only reduce your configuration by puting all your class undert the same policy-map:policy-map multi-match int70 class FW-Real loadbalance vip inservice loadbalance policy FWLB-No-LB class FW-Re...
