Previously, I use a windows XP to accept incoming connection by Network Connections > Create a New Connection > Accept Incoming ConnectionI would like to deploy an Cisco router to replace this XP, how can i configure it? I convert the RS232 to smart ...
In order to monitor juniper SSG firewall, I want to upload a Juniper netscreen 6.3 mib to Prime Infrastructure, however it prompt me for the following error message, any idea? I failed to upload all thrid party MIB, not only JuniperError :...
If I use N1000V to handle all of network traffic of my VM network, in case, one day I do some really wrong that disconnected me from N1000V and VM, how can I console to the N1000V and roll back my mistake?
Yes, since this firewall is handling thousand of users, i tried this, put a permit any ACE on the top on ACL, and found that i just receive a log entry in about 20 seconds
I got the same result on my syslog server, just a part of log is recived, i also tried, offline the ASA, directly connect a syslog server, change log server setting on ASA, then I open a Wireshar, found that, ASA not senting out those log at all, ASA...