Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I checked for this and my config did *NOT* have that command "system ignore startupconfig switch all" set, but I went ahead anb set it and then no'd it out and saved the config and reloaded and this worked for me. I'm not sure why the var wasn't set...
How/where do you set that? Is it just CAT the packages.conf file and set the boot variable to point to packages.conf? Does that CONFIG_FILE just need to be set to = startup-config or is there a specific file it should point to? in flash:? bootflash...
out put of my sh boot, sho romvar, dir, sh run all | in service, sh ver, and sh log. I've set it to boot from packages.conf (after a regular install activate commit of the bin) and the bin file both. CONFIG_FILE= is obviously blank and I would a...
Am I nuts? Lots of people asking about config-register. I don't see anyway to find or set that on a 9300 switch. Sh Ver doesn't show it, the switch all config-register command listed in here isn't recognized in config mode or just enabled mode. I...
