Dear Community,The Codecs here haven't anymore any connection to the TCU. Reboot from Codec as well TCU did not solve this even run through the wizard doesn't changed this. If anyone can help, please post here and i will send you personally the log.

Hello,the system does not start up, potentially it is stuck in bootloop. At the start there only appears shortly the CISCO Logo. I will send my contacts by mail now a log for review.

Dear Community,There was follwing emegency alert: "Application failed" "An unexpected software error was detected in python (18649) signal 6 aborted" VCS seems to working still fine.

Dear Community,There is a problem with the CISCO Edge 95 and the camera which is connected to the codec since a short time. The camera picture stays black. The camera movement is only working partial. This Issue is new, previously it has been worked....

Dear Community,I guess this camera is connected to an MXP 6000 Codec and it is possible with the remote control to move the camera. But a black picture is delivered. Do you think the camera is defect and out of this i should create a TAC?kind regards...