Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have just installed a Cisco 1552EU-E outdoor access point with the standard antennas: AIR-ANT2480V-N and AIR-ANT5180V-N. The 5 Ghz signal is great and still strong (-65 dB) even 100 meters away, however the 2.4 Ghz signal is beyond weak - 4 mete...
Hi,I am experiencing issues with the Auto Update feature for signature definitions for the 5525-X IPS module. I am using Cisco-Server auto-update with a proxy server (I am running the latest Engine Version).# sh verApplication Partition:Cisco Intrusi...
Hi,This would normally mean that you are only authenticating users, and not authorizing them. Check your authorization rules and that you have correctly configured your WLC with "Enable AAA Override".Radu
Hi,Can you try the following command on the ASA following an authentication attempt? Also, can you issue a "show run policy-map", "show run service-policy" and "show nameif" command?/pri/act# show asp table classify domain cxsc-auth-proxy hits Input ...
Hi,While using MAR to make sure that corporate users are actually using a domain computer to connect to the network was a discussion topic in several implementations, it was quickly scrapped due to the numerous issues:- Sleeping computers may not per...
Hi Atif,Check for the following:- That you have issued the command "same-security-traffic permit intra-interface" - since Anyconnect user traffic will be hair pining on the ASA Outside Interface on the Atlanta Firewall- That the Chicago IP address po...
