Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, Just wondering if that's possible to perform the following NAT but only for specific destinations ip access-list extended 150 permit 10.0.0.0 0.255.255.255 host 8.8.8.8ip access-list extended 150 permit 10.0.0.0 0.255.255.255 host 9.9.9.9 ip...
HI Guys, Situation is I have a spoke in DMVPN which needs to redistribute a couple of EIGRP routes into the cloud but the problem is that all spokes are in totally stub area which not allows you do inject any type 5 lsa. Is there any workaround? Che...
Hi Experts,After I read some documentation it is still not 100% clear for me what are the procedure to configure additional WLC controller we bought (AIR-CT2504-HA-K9). What we need to achieve is just the basic N+1 redundancy. We have our existing WL...
Hi Cisco Wireless experts,I am going to upgrade my existing AIR-WLC2106-K9 (software release 7.0.240) to AIR-CT2504-15-K9. It looks like the new one AIR-CT2504-15-K9 ships with SW 7.5.What would be the best way to transfer config to the new one with ...
Hi Martin,Many thanks for your reply.Are you sure that there will be always used the first one in the pool for PAT? What's the point of having another 253 ones ( I am not talking about huge network where 65000 sessions is not enough)?I was under impr...
Hi Traian, It's just a single L3 switch at the branch with advertises all lan subnets to the dmvpn spoke router.1. How can I create another NSSA arrea specifically for the spoke if I have a single /23 multipoint GRE on the hub? I cannot use the same ...
It will require changing it on all spokes (30 routers). So theoretically it's possible but it's a complex change. So if there is no easy workaround I will eliminate EIGRP completely on the branch site and run ospf instead.
The issue is that en password has been set but I do not remember it.Just thought there is some workaround how to get into priv mode taking into account I do have full access via ASDM.Maybe I setting up AAA would help me I am not sure.Thanks.
