No interfaces found after auto discover in CWW 6.1Cards not found = WS-X6724-SFP, WS-X6748-GE-TX, WS-SUP720. Could this be an issue with the version of Whats up Gold (v7.04 rel 2002.08.23) being too old ?
Is it possible to monitor multiple Gigabit source ports to a single Gigabit destination port set to 100Mbps half duplex (required for intrusion detection box). The last attempt resulted in the switch crashing. Am I asking too much from the switch? An...
Correct. No cards are shown, so no interfaces. Using the same auto discover on 3x 4506 Cat's with Supervisor IV & 3x WS-X4148-RJ45V all ports are found including Gig ports on the Supervisor. Any Ideas.
Thanks for the advice. I have now managed to mirror two Gigabit ports to a single Gigabit port running at 100Mbps Half duplex this should give me the info required. When the original config was installed I asked for 10 Gigabit ports to be mirrored to...
