Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
CML is a huge PITA and has me chasing problems which shouldn't be problems I would think so here I am again. 2 routers directly connected running EIGRP but won't exchange routes with each other, but will exchange routes with routers just fine on eith...
Labbing some changes up using CML (first time) and I have 2xN9ks running VPC/HSRP which that part is working.I am trying to have L3 between them for some EIGRP changes I am trying to lab but I am unable to ping between those routed interfaces. I am ...
Having an issue with new CW9172I and OSX clients dissociating for no apparent reason. Users report they lose network connectivity, no ping, no arp but they have IP addresses. At the time the issue is reported we see a ton of 802.11 disassociations i...
We just replaced a bunch of MR36s for CW91661s and having reports of slow wireless and disconnects ever since. We were able to get logs for a client that complained of wireless constantly dropping and when we looked the clients details it showed it ...
Having an issue with a dual cloud dual hub environment running eigrp. Specifically 1 spoke with 2 internet circuits (1 circuit per tunnel) not being able to form spoke to spoke traffic over its second tunnel. There seems to be an issue with the cir...
Also eigrp constantly flaps between the beta cat9000v and cat8000v..Q Cnt 1. But stays up between the cat9000 and n9k. 9500#show ip eigrp neighbors
EIGRP-IPv4 Neighbors for AS(3111)
H Address Interface Hold Uptime ...
New to CML so that was it, but when the switch says its up/up but if its 'not running' on the device itself then its down.Thanks a lot @Kasun Bandara 9k1# ping 10.99.1.18
PING 10.99.1.18 (10.99.1.18): 56 data bytes
36 bytes from 10.99.1.17: Destinat...
Not sure, because before we can really look into it the clients have already fixed it themselves by turning wireless on and off. The problem is so intermittent and hard to catch that we aren't able to reboot the APs to see if it fixes it. I can cer...
4 years later and this issue still happening which is crazy to me. Anyways this post by @JPT1456 was the solution.@@4351 w/17.9.6 > 17.12.6 after the upgrade got the same error message about not enough storage although it wasn't 0. Stuck in reboot l...
